ECU, Wireharness, Switch

Model No : GISM-E1000, Certificate : E11110R-000063 Setup Factors: Entrance Mode RPM Setting Factor Peak Time Setting Factor Fuel Meter Setting Factor Prevention "Electric Noise". Injector Change Test Factor Hold Current Duty Setting Factor Vacuum MAP Sensor Characteristic Gas Pressure Sensor Characteristic Gas Temperature Sensor Characteristic Water Temperature Sensor Characteristic Acceleration and Deceleration Setting Factor Injection Low Limit and Gas MAP Setting Factor Oxygen Sensor Controller and Setting Factor Correction MAP Setting Factor(Water-temp, Gas-temp, Delta-P, Vacuum MAP)No Need of TAP(Timing Advanced Processor) *Click on "View of Auto Calibration Menu"*Click on "Real-time Data View"*Click on "Schematic ECU Diagram for 4-cyl" Specifications Watertight by Immersion Operating Voltage : 6V ~ 18V Intergrated injectors cut and emulation Automotive Microprocessors : 16bit, 16MHz Operating Temperature Range : -40â?? ~ +105â?? Sensors and Actuators Diagnosis compatible with EOBD Protections and inlet/outlet signal according to Automotive Norms Communication & Reprogamming with PC through RS232C(will be upgraded CAN-mode) Switch :The engine can start on Gas directly when the coolant-water was warmed sufficiently.At this time, you have to push on the center of switch for 1.5 seconds. When was converted to Gas-mode under Auto-mode, the green-light is going on.When Gas-quantity will be less than 15%, the red-light is going on.