Features
We have various PTFE Water Base coatings according to the color and physical property and we are making a constant effort to develop coating materials based on the demand of customer.
Operation method
Remove contaminants -> Drying -> Sanding -> Primer Coating -> Sintering -> Mid Coating(In case of 3 Coating type) -> Top Coating -> Sintering -> Cooling
Application method
Remove contaminants : Surfaces must be clean and dry otherwise, They cause a rough surface, poor adhesion and pin holes of coating.
Sanding : The surface should be treated with sandblasting, liquid honing, or an equally effective process. When sandblasting, a 80~100 mesh sand powder should be used for the iron or stainless steel base materials.
Coating : Coating preparation
Firmly seal the container, slowly rotate the container at an angle ten times by hand, and then mix the solution with a rotating mixer until it is evenly dispersed. Do not open containers until ready to use. Keep lid on container when not in use.
Filter the solution with a 100-200 mesh stainless steel screen after rotating enough times.
Spray nozzle : 0.8-1.3mm, spray pressure : 1.5-2.5kg/m3 Recommended distance between the spray gun and the substrate : 15-25cm
2 Coating system
Item
Method
Coating Thickness
Curing Condition
Remarks
Primer
Spray
10~15um
150°C x 5min
Top
10~15um
380°C x 5min
3 Coating system
Item
Method
Coating Thickness
Curing Condition
Remarks
Primer
Spray
10~15um
150°C x 5min
Mid
10~15um
380°C x 5min
Wet on wet
Top
5~10um
Sintering
When sintering primer, temperature is 110°C ~ 180°C according to the coating.
In case of same product, As the sintering temperature is higher, quality of coating become better.
Progressively raise temperature and maintain the maximum temperature for 5 minutes.
Suddenly heating can cause air bubbles, poor adhesion
Caution
White spots may appear on the surface of the substrate when the substrate and coating is cold, especially in winter time because of a problem in coating flow. To avoid this phenomenon, please keep it warm(over 10°C) and pre-heat it before working.
Keep adequate ventilation during application
Don't mix other types of paint. especially, separate from Powder Coating.
Ideal storage temperature is 5°C ~ 30°C in warehouse.
PTFE Water Base Coating
Description
Product Inquiry
Purchase Product Catalog
Payment & Shipping Conditions:
- Payment: We accept payment through Paypal Only.
- Shipping: We will ship the catalog once the payment is received. And you will be receiving the catalog with in 10 -14 busines days. Shipping might be delayed in due to international shipping conditions which is depends on the countries receiveing. In case hard copy of catalog is not available then we will ship the soft copy.
- Refund: We can refund the order before shipping process was initiated. Incase Catalog not available, we will make sure to refund the order.
- Note: This is a Catalog Produt.
Share PTFE Water Base Coating in Social Media