Loop & Patch Handle Bag Making Machine

Specification for Loop & Patch Handle bag Making Machine(Model : TJ-7012LP_800mm, SERVO) General specs. Machine range of product Max. Film Width : 700mm (Finished bag width Max.600mm) Patch Handle film Width : Max.150mm Loop handle film width: Max.320mm Production Capacity Actual production capacity is dependent on the bag size, film thickness, material etc. To maximize production capacity, Good quality, flat/even thickness film is very essential. Estimated production speed is as followings.Patch Handle Bag : 50-60bags/minLoop Handle Bag : 40-60bags/minMachine Speed : Max.100 cycles/min Air-consumption : ABT.8Hp (Air-compressor is not included)Electricity power : ABT.12kWApplicable film : HDPE, LDPE (suitable thickness 35 - 60micron) Unwinding Unit Single Shaft unwind systems to unwind feel of PE film at a constant tension Single Roll unwinding shaft Roll Size : 500mm(D) x 700mm(W) Shaft for 3"Diameter Paper core Powder Brake & Automatic Tension controller Film exhausting sensor and automatic brake control system E.P.C (Edge Position Controller) for Web-guide control Top Folding & Bottom guess unit Slitting Knife for opening tube film Continual folding bar : Both side Bottom Gusset bar and rotary plate Guide rollers 1st Dancer Roller Unit Dancer roller is installed to compensate unbalanced feeding length between 2nd feeding and unwinding 800mm width roller Dancer speed control Regulated air loaded dancer arm assembly A.C Drive motor Longitudenal Sealing Unit After top folding, longitudinal sealing is needed for reinforce fold film Linear shaped sealing heater - 2sets Air-cylinder : 2sets Temp. Controller installed independently Patch Handle Unit Unwinding Shaft Patch film Feeding : By Air-cylinder Cutting type : Heated flying cutter Sucking & Rotary plate Sealing Bar : 2sets (upper & lower) Reinforce Sealing Unit Reinforce sealing Heater : Cartridge heater 2sets (Up & Down) Air-cylinder type Temp controller installed Loop Handle Unit Unwinding shaft: 400MM width Loop film supplying: by Gear Cutting type: Knife cutting by Air-cylinder Loop film holding and transferring to inside of main film: by Gear Loop sealing: Total 4sets (Up&Down, Left and Right) PLC control system Punching Unit For Patch Handle bag& Die-Cut handle bag Air-cylinder Handle shape : Buyer's choice P.L.C Control System Main Feeding A.C Servo Drive system feed the film accurately ad desired length to the sealing station Driven by A.C Servo Motor (Mitsubishi brand) Air-Finger bar installed upper & lower Automatic Bag length adjustment : variance +/-0.1mm Mark Sensor installed for sensing sealing position Main Sealing & Cutting Sealing bar : Cartridge Heating method - 800mm(Side sealing type) Rotary type Silicon roller Out-feeding conveyor installed P.L.C Control Main Motor : A.C 3Hp(Inverter Speed Control) Conveyor Independent counter via P.L.C Control A.C Drive motor Auto-counter & Buzzer Conveying by Belt